HP 5100 - Page 153

ENWW Control Panel Menus B-17
I/O BUFFER SIZE=
100K
10K
and up This item appears only when I/O
BUFFER=ON
. Specify the amount of memory
for I/O buffering. The maximum amount of
memory available for I/O buffering is
determined by the amount of memory installed
in the printer, the languages installed in the
printer, and by other memory allocations that
must be made.
Press [-Value +] to change settings by
increments of 10 (up to 100 KB) or by
increments of 100 (above 100 KB).
PARALLEL HIGH
SPEED=YES
YES
NO
Select the speed at which data is transmitted
to the printer.
YES: The printer accepts faster parallel
communications used for connections with
newer computers.
NO: The printer accepts slower parallel
communications used for connections with
older computers.
PARALLEL ADV
FUNCTIONS=ON
ON
OFF
Turn the bidirectional parallel communication
on or off. The default is set for a bidirectional
parallel port (IEEE-1284).
This setting allows the printer to send status
readback messages to the computer. (Turning
the parallel advanced functions on might slow
language switching.)
I/O Menu (Continued)
Item Values Explanation