ENWW Chapter 2: Printing Tasks 43
Printing Transparencies
Use only transparencies recommended for use in laser printers. For
transparency specifications, see page A-10.
• Load transparencies in Tray 1 with the side-to-be printed facing
up and the top edge toward the right.
• To prevent transparencies from becoming too hot or sticking
together, use the top output bin by closing the rear output bin
(page 25). Remove each transparency from the output bin before
printing another.
• Place transparencies on a flat surface to cool after removing them
from the printer.
Figure 14 Printing Transparencies
To Next Page
Loading...