Checking DIMM installation
After installing the DIMM, make sure that the installation was successful.
To verify that the DIMM is installed correctly
1. Turn the printer on. Check that the Ready light is illuminated after the printer has gone through
the startup sequence. If an error message appears, the DIMM might have been incorrectly
installed. See
Control-panel messages.
2. Print a configuration page (see
Using printer information pages).
3. Check the memory section on the configuration page and compare it to the configuration page
that was printed before the memory installation. If the amount of memory has not increased, the
DIMM might not be installed correctly, or it might be defective. Repeat the installation
procedure. If necessary, install a different DIMM.
NOTE If you installed a printer language (personality), check the "Installed Personalities and
Options" section on the configuration page. This area should list the new printer language.
182 Appendix E Working with memory ENWW
To Next Page
Loading...