HP 5200L Series

Language
If LANGUAGE appears in English on the control panel, use the following procedure. Otherwise, turn
the printer off and then on again. When XXX MB appears, press and hold
. When all three control
panel lights are lit, release
and use the following procedure to set the language.
Selecting the language during initial installation
1. Turn on the printer.
2.
When LANGUAGE appears on the control-panel display in the default language, press
to
highlight the preferred language, and then press
.
Changing the language after the initial configuration
After the initial installation, you can change the control-panel display language from the control panel.
1. Press Menu.
2.
Use
to highlight CONFIGURE DEVICE, and then press
3.
Use
to highlight SYSTEM SETUP, and then press
4.
Use
to highlight LANGUAGE, and then press
5.
Use
or to highlight the appropriate language, and then press .
6. Press Menu to exit the menu.
42 Chapter 2 Control panel ENWW