3. Slide the media-width guides slightly wider than the media.
4. Place media into the tray (short-edge in, print-side up). The media should be centered between
the media-width guides and under the tabs on the media-width guides.
5. Slide the media-width guides inward until they lightly touch the media stack on both sides
without bending it. Make sure that the media fits under the tabs on the media-width guides.
NOTE Do not add media to tray 1 while the printer is printing. This could cause a jam. Do
not close the front door when the printer is printing.
54 Chapter 4 Printing tasks ENWW
To Next Page
Loading...