3. Turn the computer right-side up, with the front toward you.
4. Open the computer as far as possible.
5. Disconnect the display panel cables (1) and (2) from the system board.
6. Remove the wireless antenna cables (3) from the clips and routing channels built into the top cover.
7. Remove the four slotted Torx ST8M2.5×7.0 screws (1) that secure the display assembly to the
computer.
CAUTION: Support the display assembly when removing the following screws. Failure to support
the display assembly can result in damage to the display assembly and other computer
components.
8. Lift the display assembly (2) straight up and remove it.
56 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
