Models
HP 6200-24G-mGBIC yl Switch
J8992A
Introduction
The HP 6200-24G-mGBIC yl Switch is an advanced Layer 3 stackable switch in 1U height. It has 24 mini-GBIC slots and an expansion slot
for an optional 4-port 10GbE module.
Designed to be deployed as an aggregator of traffic from the edge to the core of the network, this switch supports a variety of Gigabit
mini-GBICs, such as SX, LX, LH, and 1000BASE-T. The foundation for this switch is a purpose-built ProVision ASIC that allows the most
demanding networking features, such as quality of service (QoS) and security, to be implemented in a scalable yet granular fashion.
With its high-performance architecture, 10GbE capability, and programmable ASIC, this switch offers excellent investment protection,
flexibility, and scalability.
Key features
Distribution layer
Layer 2 to 4 and intelligent edge feature set
High performance
Low-cost mini-GBIC connectivity
10GbE uplinks
Features and Benefits
Software-defined networking
NEW
OpenFlow
supports OpenFlow 1.0 and 1.3 specifications to enable SDN by allowing separation of the data (packet forwarding) and control
(routing decision) paths
Quality of Service (QoS)
Advanced classifier-based QoS
classifies traffic using multiple match criteria based on Layer 2, 3, and 4 information; applies QoS policies such as setting priority
level and rate limit to selected traffic on a per-port or per-VLAN basis
Layer 4 prioritization
enables prioritization based on TCP/UDP port numbers
Traffic prioritization
allows real-time traffic classification into eight priority levels mapped to eight queues
Bandwidth shaping
:
Port-based rate limiting
provides per-port ingress/egress enforced maximum bandwidth
Classifier-based rate limiting
uses access control list (ACL) to enforce maximum bandwidth for ingress traffic on each port
QuickSpecs
HP 6200 yl Switch Series
Overview
DA - 12437 North America — Version 17 — December 9, 2013
Page 1
To Next Page
Need help?
General
