5. Remove the drive from the drive bay as follows:
●
To remove a 5.25-inch drive in the desktop configuration, press down on the yellow
drivelock mechanism (1) and slide the drive from the drive bay (2).
CAUTION: When the yellow drivelock is pressed, all the 5.25-inch drives are released so
do not tilt the unit and allow the drives to fall out.
Figure 6-15 Removing a 5.25-inch Drive in the Desktop Configuration (Optical Drive
shown)
●
To remove a 5.25-inch drive in the minitower configuration, pull up on the green drivelock
mechanism (1) for that specific drive and slide the drive from the drive bay (2).
Figure 6-16 Removing a 5.25-inch Drive in the Minitower Configuration (Optical Drive
shown)
90 Chapter 6 Removal and Replacement Procedures – Convertible Minitower (CMT) Chassis
To Next Page
Loading...
