h.
Display assembly (see
Display assembly on page 79)
i. Top cover (see
Top cover on page 84)
j.
Speaker assembly (see
Speaker assembly on page 87)
k. Modem module (see
Modem module on page 89)
l. System board (see
System board and system board frame on page 90)
Remove the USB/audio board:
1. Remove the two Phillips PM2.5×4.0 screws (1) that secure the USB/audio board to the base
enclosure.
2. Lift the left side of the USB/audio board (2) until the USB and audio connectors disengage from
the openings in the base enclosure.
3. Remove the USB/audio board and cables from the base enclosure.
Reverse this procedure to install the USB/audio board.
98 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
