4.
Remove the battery (see
Battery on page 47).
5. Remove the following components:
a.
Keyboard (see
Keyboard on page 58)
b. Fan (see
Fan on page 63)
c. Heat sink (see
Heat sink on page 64)
Remove the graphics card:
1. Remove the two Phillips PM2.0×3.0 screws (1) that secure the graphics card to the computer. (The
edge of the board opposite the graphics card slot rises away from the computer.)
2. Remove the graphics card (2) by sliding it away from the graphics card slot at an angle.
NOTE: The graphics card is designed with a notch (3) to prevent incorrect installation.
Reverse this procedure to install the graphics card.
Component replacement procedures
69
To Next Page
Loading...
