2.
Remove the wireless antenna cables from the clips (2) and (3) and routing channels (4) built into
the top cover.
3. Remove the following screws:
(1) Two Torx T8M2.5×9.0 screws
(2) One Phillips PM2.5×4.0 screw
(3) Two Phillips PM2.0×2.0 screws
4.
Position the computer with the rear panel toward you.
5. Remove the four Torx T8M2.5×9.0 screws (1) that secure the display assembly to the computer.
80 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
