8. If it is necessary to replace the display bezel or display hinges, remove the following:
(1) Four rubber screw covers on the display bezel top edge
(2) Two rubber screw covers on the display bezel bottom edge
(3) Four Phillips PM2.5×7.0 screws on the display bezel top edge
(4) Two Phillips PM2.5×7.0 screws on the display bezel bottom edge
NOTE: See Display inverter on page 48 for display inverter replacement instructions.
9. Flex the inside edges of the left and right sides (1) and the top and bottom sides (2) of the display
bezel until the bezel disengages from the display enclosure.
10. Remove the display bezel (3). The display bezel is available using spare part numbers 501111-001
(for use with computer models equipped with WLAN and WWAN capability) and 501112-001 (for
use with computer models equipped with WLAN and WWAN capability and with webcam).
11. If it is necessary to replace the display hinges, remove the four Phillips PM2.5×5.0 screws (1) that
secure each display hinge to the display panel.
72 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
