HP 8642A Operation And Calibration Manual

Operation
Model 8642A/B
Relative Amplitude (cont'd)
Related
Operating
Instructiolls
3-82
Relative Amplitude Sweep
It is not possible to set an amplitude sweep directly in relative units. Refer to page
3-205 for amplitude units conversion information to determine amplitude sweep start
and stop end-points in absolute units.
Refer to Amplitude (page 3-69) for additional information about setting amplitude.
Refer to Knob (page 3-141) and Step, Increment Set (page 3-149) for information on
using these to modify settings.
Refer to Instrument Preset, Partial Prl'set (page 3- I 39) for information on setting the
intrumen t to an initia hz.ed sta te t ha t maintains prese t references including the
selected amplitude unIts.
Refer to Operating Messages (page .)-177) if the instrument displays a message you
want clarified.

HP 8642A Specifications

General

Brand	HP
Model	8642A
Category	Inverter
Language	English