451
Chapter 8, Programming The Call Processing Subsystem
Using the Call Processing Subsystem’s Remote User Interface
Figure 32 Connecting a Mobile Station to the Test Set
NOTE: Do not connect the antenna of the mobile station to the ANT IN port on the front panel of the
Test Set as this will cause the overpower protection circuitry to trip when the mobile station
is transmitting. Refer to the ANT IN field description in the User’s Guide for further
information.
Refer to the User’s Guide for detailed information on connecting a mobile station
to the Test Set.
ANT IN
Manufacturer’s
Special Fixture
AUDIO OUT
RF IN/OUT
AUDIO IN
LO
HI
Antenna
Speaker Out
Microphone In
Mobile Station
To Next Page
Loading...
