HP 8920A - Page 461

461
Chapter 8, Programming The Call Processing Subsystem
Programming The CALL CONTROL Screen
[] Access
When lit, the Access annunciator indicates that the Test Set is signaling the
mobile station with command information on the forward voice channel. This is a
transitory state.
The
Access annunciator is not programmable.
The state of the
Access annunciator is reflected in the Call Processing Status
Register Group Condition Register bit 4. See “Status Reporting” in the User’s
Guide for further information.
The Test Set’s speaker is turned off when in the Access state. This is done to
eliminate any possible audio feedback which may occur if the mobile station’s
microphone is open.
Active
This field is used to turn on the forward control channel of the Test Set or to force
a return to the
Active state from any other state (Register, Page, Access,
Connect).
If the forward control channel of the Test Set is already active, sending the
:ACTive command will deactivate and then reactivate the control channel.
The :ACTive command is used to control this field.
There is no query form of the :ACTive command.
Syntax
:ACTive
Example
OUTPUT 714;"CALLP:ACT"