5-2
9030/40 Diagnostics
Error
Code
#6
Error
Code
#9
Error
Code
#11
BAD
CARD
DR
DEVICE:
NNNNN
BAD
CARD
DR
DEVICE:
SELECT
CODE
NN
- Informational message. A hardware failure has been detected (interface card or
mass storage device did not pass the Module Self-Test). The loader continues
searching for an operating system.
Possible causes: bad interface card or mass
storage device.
DEVICE
NOT
READY:
NNNNN
VOLUME
NOT
MOUNTED:
NNNNN
MEDIA/DEVICE
NOT
READY:
SELECT
CODE
NN
- While loading, the media (Volume) was removed from the device (e.g. a floppy
disc was pulled out of a disc drive), the device went offline, or a hardware problem
caused the device to become
"not
ready".
DMA
FA
I
LED:
NNNNN
- Data did not transfer properly from the mass storage device
to the computer.
Possible cause:
Mass
storage device hardware failure or computer
hardware failure.
UNRECOVERABLE
DATA:
NNNNN
UNRECOVERABLE
DATA:
SELECT
CODE
NN
- Part of the operating system
is
not readable. Possible causes: media failure or
mass storage device hardware failure.
Error
Code
END
OF
IjOLUME:
NNNNN
# 12
END
OF
VOLUME:
SELECT
CODE
NN
Error
Code
#13
Error
Code
#14
Error
Code
#15
Error
Code
#16
Error
Code
#17
Error
Code
#18
Error
Code
#19
- Attempt to address or read past the end of a volume. Possible causes: corrupt
system, media failure or mass storage device hardware failure.
CTRLR/UNIT
FAULT:
NNNNN
CTRLR/UNIT
FAULT:
SELECT
CODE
NN
- Hardware passed
initial
self-test. However.
it
failed while being used to load the
operating system.
Possible causes: computer (interface card) hardware failure or
mass storage device hardware failure.
10
TIMEOUT:
NNNNN
10
TIMEOUT:
SELECT
CODE
NN
- Mass storage device failed to respond
fast
enough while attempting to load from
it.
Possible cause: computer hardware failure or mass storage device hardware
failure.
CSSO
DEVICE:
NNNNN
CSSO
DEVICE:
SELECT
CODE
NN
- Indicates a mass storage device hardware failure.
TAPE
DEVICE:
SELECT
CODE
NN
-Usually indicates a tape device (HP 7970,
HP
7974, HP 7978) hardware failure. Can also indicate a failure on the HP 27110A
HP-IB Interface (or the Internal HP-IB interface). Tape errors covered are: "Com-
mand Rejected", "Interface Busy", "Rewinding", "Tape Runaway", "Data Timing
Error",
and
"Command Parity Error".
HPIB
CARD:
NNNNN
HPIB
CARD:
SELECT
CODE
NN
- Transaction to the indicated HPIB interface card was terminated due to a prob-
able interface card failure.
BAD
10
BUS:
NNNNN
BAD
10
BUS:
SELECT
COOE
NN
- Indicates a computer hardware failure on the computers
first
lOP.
BAD
NI)M:
NNNNN
BAD
NVM:
SELECT
CODE
NN
- Indicates that Non-Volatile Memory failed
its
self-test. Possible cause: computer
hardware failure.
To Next Page
Loading...
