D. Press Enter. The IP Address Exclusion List screen appears.
E. Enter n for next. The IP Address Inclusion list and IP Address Exclusion list appears.
Note: You can add or delete as many IP addresses or IP address ranges as you want.
3. Enter n for next.
• To disable IP Restricted Login:
Enter 2 to disable IP Restricted Login, which sets it to OFF. IP Restricted Login: OFF
appears.
Note: Only IPv4 address ranges are supported for IP restricted login.
9. Enter n to go to the next screen. The configuration completes, and a message appears indicating that
HP SMH is successfully set up. The HP SMH service stops and starts automatically.
10. Verify HP SMH is configured and working properly by navigating to it and verifying that it appears as
you configured HP SMH during installation.
Configuring HP SMH 57
To Next Page
Loading...
Need help?
General