console output. In order to access the server console, type the MP IP address in Internet Explorer
(for iLO interface) or in a telnet session or SSH client (for MP interface).
If you must force the target server to reboot, you can type restart at the WinPE SAC or use the
MP command line interface. To use the MP command line interface, follow these steps:
1. Connect to the target server through either telnet or SSH in order to access the MP. At any
time, type Ctrl+B to return to the MP.
2. Enter the command menu as follows:
servernameMP> CM
3. Reset the system. Enter:
servernameMP> RS
Monitoring the Deployment 29
To Next Page
Loading...
Need help?
General