HP Brocade 8Gb - 2 Setup and Configuration Procedures; Shipping Carton Contents and Installation Safety

2 Setup
This chapter provides the following information:
• Shipping carton contents, page 19
• Installation and safety considerations, page 20
• Install the 8Gb SAN Switch, page 20
• Set the IP address, page 23
• Configure the 4Gb SAN Switch, page 25
Shipping carton contents
Figure 3 and Table 8 identify the 8Gb SAN Switch shipping carton contents:
• Brocade 8Gb SAN Switch for HP BladeSystem c-Class installation instructions
• SFP dust covers (must be inserted in ports where Small Form-factor Pluggable (SFP) optical trans-
ceivers are not installed)
• Four Short Wavelengh (SWL) 8Gb SFPs, (in styrofoam packing)
• One Brocade 8Gb SAN Switch; models include:
• Brocade 8/12 SAN Switch for HP BladeSystem c-Class with twelve active ports
• Brocade 8/24 SAN Switch for HP BladeSystem c-Class with sixteen internal and eight external
active ports
• Brocade 8/24 SAN Switch Power Pack+ for HP BladeSystem c-Class with sixteen internal and
eight external active ports
Figure 3 Carton contents
.
Table 5 identifies 8Gb SAN Switch components.
Table 8 Brocade 8Gb SAN Switch components
DescriptionItem
Brocade 8Gb SAN Switch, ships with four Short Wavelengh (SWL) 8Gb SFPs, (in styro-
foam packing)
1
Brocade 8Gb SAN Switch for HP BladeSystem c-Class 19