What to do if link light does not light when a cable is connected to HP ProCurve 1400-24G Switch?
If the link light on your HP Switch doesn't illuminate when a cable is connected, check for loose or faulty connections. Ensure all connections are secure. If the problem persists, try using a different cable.
General| Model | HP ProCurve 1400-24G |
|---|---|
| Ports | 24 x 10/100/1000 |
| Switching Capacity | 48 Gbps |
| Forwarding Rate | 35.7 Mpps |
| Layer | Layer 2 |
| Jumbo Frame Support | Yes |
| MAC Address Table Size | 8000 entries |
Details the physical components and front panel indicators of the switch.
Explains the different types of ports (RJ-45, dual-personality) and their connectivity.
Explains the function of switch LEDs for status monitoring.
Lists all components included with the ProCurve Switch 1400-24G.
Outlines the step-by-step process for installing the switch.
Provides essential safety and environmental guidelines for installation.
Lists common problems and their potential solutions.
Explains how to interpret LED patterns for issue identification.
Describes how to reset the switch to test its functionality.
Provides dimensions and weight of the switch.
Details voltage, current, and frequency range.
Lists operating and non-operating temperature and humidity ranges.
Covers general safety warnings, grounding, and servicing information.
Details electromagnetic compatibility standards and regional compliance.
Provides guidelines for disposing of waste equipment according to WEEE directives.
To Next Page
