What to do if link light does not light when a cable is connected to my HP 1800 24G - ProCurve?
If the link light on your HP Switch doesn't illuminate when a cable is connected, begin by inspecting for loose or visibly faulty connections. If the connections appear to be in good condition, ensure they are firmly attached. Should the problem persist, attempt using a different cable.
General| Model | HP 1800 24G |
|---|---|
| Type | Managed |
| Layer | Layer 2 |
| Switching Capacity | 48 Gbps |
| Forwarding Rate | 35.7 Mpps |
| Jumbo Frame Support | Yes |
| Power Consumption | 30 W |
| MAC Address Table Size | 8, 192 entries |
| Operating Temperature | 0°C to 50°C |
| Operating Humidity | 15% to 95% non-condensing |
| Ports | 24 x 10/100/1000 ports 2 x dual-personality ports - 10/100/1000 or mini-GBIC |
Guide on configuring the IP interface for management access to the switch.
Steps to assign a new administrator password for the web agent to enhance security.
Guide on creating, deleting, or modifying VLANs based on the 802.1Q standard.
Procedures to reset the switch to its original factory default configuration.
Lists common problems and their solutions for the switch.
Steps to restore the switch to factory defaults if the IP or password is lost.
To Next Page
