HP 1800 24G - ProCurve Switch - Ping Test

2-34
Using the ProCurve Web Browser Interface
Web Configuration
Using the ProCurve Web
Browser Interface
Ping Test
This operation allows you to test the network connections by sending an
Internet Control Message Protocol (ICMP) echo request packet from the
switch to other devices on the network. The page will display the results of
the operation.
Field Attributes
Ping Parameters
• Target IP Address – The IP address of the device to ping on the
network.
• Count – Number of packets to send. (Default: 1)
• Time Out (in secs) – Number of seconds to wait for a response.
(Default: 1)
Ping Results
• Target IP Address – The IP address of the device to ping on the
network.
• Status – Displays the current status of the ping operation.
• Received replies – Number of replies received.
• Request timeouts – Number of times the network device failed to
respond in the given time.
• Average Response Time (in ms) – Average response time of all the
packets.