TAG 809: Blurred or Smeared Vertical Streaks on Prints
3-178 Troubleshooting Analysis Guide (TAGs) June 1999
10
Run test prints. Use extreme caution:
• Check J/P22-1 to J/P22-2 for 100 Vac.
Is the voltage 100 vac?
No: Continue.
Yes: Replace the vacuum transport unit, then turn to TAG 002: Check & Problem Resolution.
11
Run test prints. Use extreme caution:
• Check J/P13-6 to J/P13-3 for 100 Vac.
Is the voltage 100 vac?
No: Replace the power control #2 board, then turn to TAG 002: Check & Problem Resolu-
tion.
Yes: Repair or replace the connectors or wiring from J22-1 to P13-6 or J22-2 to P13-3, then
turn to TAG 002: Check & Problem Resolution.
12
Inspect the fuser drive assembly and the fuser drive belt for damage or a slipping belt.
Are they in good working order?
No: Replace the parts that are defective, then turn to TAG 002: Check & Problem Resolution.
Yes: Replace the printhead assembly, then turn to TAG 002: Check & Problem Resolution.
To Next Page
Loading...