Upper Cassette Mount Removal
June 1999 Removal/Replacement Procedures 7-41
Upper Cassette Mount Removal
To remove the upper cassette mount:
1 Open the front, back, and top covers.
2 Duplex only: Remove the duplex tray.
3 Remove the upper and lower paper cassettes.
4 Remove the left side cover (see page 7-8).
5 Remove the paper feed drive cover (three screws).
6 Remove the power control board cover (one screw).
7 From the back, remove the two screws holding the upper cassette mount in place.
8 Loosen the CN62 jack and pull it to the back of the printer.
9 Disconnect CN62.
Mounting Screws
CN62
Back Detail
Power Control
Board Cover
Paper Feed Drive Cover
To Next Page
Loading...