“C” Roller Solenoid Removal
7-100 Removal/Replacement Procedures June 1999
“C” Roller Solenoid Removal
To remove the “C” roller solenoid:
1 Open the top cover.
2 Remove the front mechanism cover (two screws).
3 Disconnect CN315 and cut the cable tie securing the wires to the mounting plate.
4 Remove the two screws holding the “C” roller solenoid in place.
5 Loosen the set screw securing the actuator arm to the “C” roller.
6 Disengage the solenoid from the actuator arm and remove it.
Replacement Note:
Install a new cable tie to secure the wires from CN315 to the mounting plate.
Actuator Arm
Mounting Screws
C Roller Solenoid Detail
CN315
To Next Page
Loading...