HP C30 - Page 48

Error Code/TAG Cross-Reference
2-8 June 1999
552 No serial controller/DMAC interaction 200
553 Serial controller/DMAC transfer count error 200
554 Serial controller/DMAC transfer error 200
555 RS232 send/receive path error 200
556 RS232 DTR/DTC path error 200
557 RS232 RTS/CTS path error 200
558 RS422 send/receive path error 200
559 RS422 send clock/receive clock path error 200
560 CRTC register read/write error 200
561 No page begin (PIT2) interrupt 200
562 No CRTC address generation 200
563 No VSYNC generation (end of page) 200
564 No end of page (PIT2) interrupt 200
565 No CRTC count termination 200
566 VSYNC timeout error 200
570 Drive controller/SCSI read/write error 200
571 Drive controller busy timeout 200
572 Diskette is write protected 130
573 Drive not ready 130
574 Drive controller restore error 130
575 Drive controller seek error 130
576 Drive controller read sector error 130
577 Drive controller read sector data/checksum error 200
578 Drive controller write sector error 200
579 Drive controller read/modify/write error 200
580 No drive controller/PIT0 interrupt 200
581 No drive controller-DMA interaction 200
582 Drive controller/DMAC transfer error 200
583 Drive controller/DMAC transfer count error 200
584 Drive controller/DMAC read sector error 200
585 Drive controller/DMAC write sector error 200
586 Drive hard error 130
Table 2-9. Bit Map RAM Error Codes
Code Bit Map RAM Error Code Meaning Go to TAG
600 Bit-map RAM data path error 200
Table 2-8. IGS/Disk Drive Error Codes (Continued)
Code Disk Drive Error Code Meaning Go to TAG