TAG 002: Check & Problem Resolution
3-8 Troubleshooting Analysis Guide (TAGs) June 1999
the magnetic roller.
• Reinstall the developer unit.
6 Inspect and clean the cleaner unit/charge corona:
• Inspect the unit for damage or contamination; repair or replace as necessary.
• Remove the charge corona from the cleaner unit.
• Clean the grid with the cleaner brush.
• Remove the grid to expose the corona wire.
• Clean the corona wire with a cotton swab or corona cleaning tool.
• Reinstall the grid.
• Clean any excess toner from the cleaner unit with a soft cloth.
• Reinstall the charge corona in the cleaner unit.
• Reinstall the cleaner unit.
7 Clean and inspect the photoconductor unit area
• Clean the photoconductor seam sensor inside the printer with a cotton swab or compressed
air.
• Remove the photoconductor from its protective packaging.
• Inspect the photoconductor for damage or contamination; repair or replace as necessary.
• Reinstall the photoconductor unit.
8 Clean the transfer corona
• Remove the transfer corona.
• Clean the transfer corona housing with a soft cloth.
• Clean the transfer corona wire with a cotton swab.
• Reinstall the transfer corona.
Have you completed the every-call cleaning procedure?
No: Complete the procedure, then continue.
Yes: Continue.
Caution
Handle gently to avoid breaking the corona wire
Caution
Do not touch the photoconductor belt as this
permanently
damages the unit
Caution
Handle gently to avoid breaking the corona wire
To Next Page
Loading...