EasyManua.ls Logo

HP Cluster Platform Introduction v2010 - Information on Ergonomics

HP Cluster Platform Introduction v2010
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
Connection to the server management interface, a dedicated hardware interface that listens
for, and executes commands received through the Ethernet network. This card is also known
as the management processor (MP), or integrated lights-out (iLO) card, depending on the
model of server. Where supported by the operating environment, this connection is used
for server hardware management functions, such as power-off or boot.
6
NIC dedicated to the Message Passing Interface (MPI)
7
Compute nodes
8
Common Gigabit Ethernet network, used both for MPI traffic, and for in-band job
management, and cluster administrative functions
9
Gigabit Ethernet switch, used as the system interconnect
Figure 2-7 shows a topology based on a dedicated MPI fabric. This might be built around Gigabit
Ethernet or InfiniBand. A second Ethernet network provides routing for cluster administrative,
and job management traffic. A third network is provided through the site LAN connection.
Figure 2-7 Three-Network Topology
The following cluster features are shown in Figure 2-7:
1
Site LAN connection
2
LAN network, connected to a network interface card (NIC) installed (or embedded) in
the head node
3
The server designated as the head node (control node in HP Cluster Platform terminology)
4
NIC dedicated to the LAN network
5
NIC connected to a dedicated Gigabit Ethernet MPI network, if present
6
Connection to the server management interface, a dedicated hardware interface that listens
for, and executes commands received through the Ethernet network. This card is also
known as the management processor (MP), or integrated lights-out (iLO) card, depending
on the model of server. Where supported by the operating environment, this connection
is used for server hardware management functions, such as power-off or boot.
7
NIC connected to a shared Gigabit Ethernet MPI network, if present
8
Host Channel Adapter (HCA) card, connected to an InfiniBand MPI network, if present
9
Compute nodes
10
Ethernet network for cluster administration
11
Gigabit Ethernet MPI network, if present
16 Supported Configurations

Table of Contents

Other manuals for HP Cluster Platform Introduction v2010

Related product manuals