3.
Use the
(Left arrow) or
(Right arrow) button to select Link Speed, and then press
(Select).
4.
Use the
(Left arrow) or (Right arrow) button to select one of the following settings.
●
10T Full
●
10T Half
●
100T Full
● 100T Half
NOTE The setting must match with the network device to which you are connecting (a
network hub, switch, gateway, router, or computer).
5.
Press
(Select). The printer will power cycle.
ENWW Using the printer control panel 83
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...
