C7085-90921 Chapter 7 Troubleshooting 221
FUSER LIFE LOW
REPLACE KIT (4500)
-or-
FUSER LIFE LOW
ORDER KIT (4550)
Description:
Approximately 95% of the fuser’s life has been consumed.
Action:
Continue printing, or replace the fuser kit. Fuser replacement
will be required in the near future.
Fuser Life Out
Replace Kit
Description:
The fuser has reached the end of its expected life.
Action:
Replace the fuser kit.
INITIALIZING
Description:
The message appears when the printer is initially turned on.
Action:
No action required.
INSTALL DRUM KIT
Description:
The drum kit is not installed or is incorrectly installed.
Action:
Verify that the drum kit is correctly installed.
INSTALL TRAY 2
Description:
The printer cannot print until media is loaded into Tray 2. The
paper path for Tray 3 passes through Tray 2.
Action:
Insert Tray 2 into the printer so that printing from Tray 3 can
continue or start.
MEMORY FULL
STORED DATA LOST
Description:
The printer has no available memory. The current job might
not print correctly. Some downloaded fonts might have been
deleted.
Action:
Try printing simplified pages. If this does not resolve the
problem, add printer memory.
MEMORY SETTINGS CHANGED
Description:
The I/O buffering settings were changed by the printer
because there is not enough memory available to use the
previous settings.
Action:
No action required. However, adding printer memory might
prevent this from occurring.
MEMORY SHORTAGE
JOB CLEARED
Description:
The available memory was not enough to continue printing.
The remainder of the job was canceled.
Action:
No action required. However, adding printer memory might
prevent this from occurring.
MEMORY SHORTAGE
PAGE SIMPLIFIED
Description:
The printer’s adaptive data compression had to resort to
lossy compression to fit raster graphics in the available
memory. This has caused a data loss in the raster output.
Action:
1. Reduce the complexity of the page to improve the print
quality.
2. Adding memory will not correct this problem.
NO JOB TO CANCEL
Description:
[Cancel Job] was pressed but there is no active job or
buffered data to cancel. The printer automatically returns to
the
READY state.
Action:
No action required.
Table 7-2 Alphabetical printer error messages (continued)
To Next Page
Loading...