230 Troubleshooting C7085-90921
49 ADAC or AFAC
Description:
Indicates that the printer is printing a PostScript file
using Windows 3.1 or 9x.
Action:
No action required.
49 FF01 to FF05
Description:
An NEC firmware ROM error has occurred.
Action:
Replace the firmware.
49 FF02
Description:
Unsupported EDO memory has been installed.
Action:
Remove unsupported memory.
49 04CC
Description:
Indicates a media timing issue. This occurs when
printing multiple copies of transparencies or heavy
or glossy media with either the PCL or PostScript
drivers. Or it could indicate a timing mismatch
between the engine and formatter.
49 04E7
Description:
Occurs during decompression of the strip buffers
when the end of the strip marker is missing. This is
triggered by one of the following: 1) Marker is
corrupt; 2) Strip buffer size given to HiLite is too
small; 3) Strip buffer size given is too large.
Note This error is primarily associated
with the firmware and should not
require a new formatter.
49 04FF
Description:
A large print job (800 to 1200 pages) or complex
graphics can cause the printer to quit printing.
Action:
Two courses of actions are available:
Determine the page that is causing the failure.
If there is an image on the page, try to move
the image down on a portrait page or left on a
landscape page to move the image out of the
strip that is failing. The movements will need to
be very small so as not to cause the next strip
to fail.
Put the printer in Lossy mode with a sequence
of PJL commands. (Lossy compression is the
process of compressing a file such that some
data is lost after the file is compressed and
decompressed.) Use the following series of
commands to put the printer into Lossy mode:
ESC%-12345X@PJL
@PJL Default Service mode=HPBOISEID
@PJL Default Diagnostics=ON
@PJL Enter Language = PCL
ESC%-12345X@PJL
Esc*z9999P
Esc*z50P
Esc*z201X
(Continued on next page)
Table 7-3 Numerical printer error messages (continued)
To Next Page
Loading...