C7085-90921 Chapter 3 Installation and configuration 49
Unpacking the printer
Note
Save all of the packing materials in case you need to repack and
transport the printer at a later date.
WARNING!
The base and N model printers weigh approximately 57 kg (125 lb). The
DN model weighs 77 kg (169 lb) with Tray 3 and the duplex unit
installed.
HP recommends having two or more people lift or move any of the
printers.
1 Using safe lifting techniques, remove the printer and the printer
accessories from the box.
CAUTION
The prepared location must be level (not more than a 2° angle), able to
support up to 77 kg (169 lb), and must support all four corners of the
500-sheet paper feeder (serves as printer base).
2 Place the 500-sheet feeder in the prepared location.
CAUTION
Avoid bending the guide pins while assembling the printer.
3 Using the guide pins for proper alignment, carefully assemble the
printer and accessories.pen the ITB drawer and remove the packing
tape, then close the drawer.
4 Open the ITB drawer and remove the packing tape, then close the
drawer.
1
3
2
4
To Next Page
Loading...