C7085-90921 Chapter 3 Installation and configuration 57
Installing the imaging drum
CAUTION
Avoid exposing the imaging drum to direct light. Exposure to light for
more than 15 seconds can seriously damage the imaging drum.
1 Pull open the drum drawer until it stops.
2 Align the imaging drum over the drawer so that the arrow on top
points to the rear of the printer, and the blue end cap on the side
slides into the slot identified with the blue arrow.
3 Slide the imaging drum down into place.
4 Push the front upper drawer shut. Wait while the printer runs an
internal color calibration. The calibration takes a few minutes. When
the printer is ready, the control panel displays
READY.
CAUTION
If you need to ship the printer, remove the toner cartridges and imaging
drum before shipping.
10
9
1
2
3
4
To Next Page
Loading...