72 Installation and configuration C7085-90921
IBM OS/2 LAN Server and Warp Server networks
For IBM OS/2 LAN Server and Warp Server Networks, HP JetAdmin software supports the Data
Link Control (DLC) environment. Depending on the number of network printers and type of printer
driver, when using virtual memory, improved performance might be realized by increasing server
RAM, especially if the swapper.dat file is large.
LocalTalk network
The LocalTalk interface enables you to print directly from a stand-alone Apple Macintosh computer
or from a Macintosh computer on a LocalTalk network. For specific information about configuring
your computer and printer to print through a LocalTalk interface, refer to the printer’s getting started
guide and the HP JetDirect Print Server Software Installation Guide.
Macintosh DIN-8 cable
To connect a Macintosh computer directly to this printer, use a standard Macintosh DIN-8 printer
cable. This cable cannot be used in a network configuration.
Note For LocalTalk configuration, the DIN-8 printer cable must be plugged into the printer port of your
Macintosh computer.
LocalTalk configuration
To connect the printer to a Macintosh computer on a LocalTalk network, use the HP LocalTalk
Cable Kit. You will need a kit for each printer and an additional kit for each Macintosh computer on
your network.
UNIX networks
HP JetAdmin software provides a TCP/IP-based solution for configuring and managing HP
JetDirect print servers on HP-UX, Solaris, and SunOS systems.
To Next Page
Loading...