C7085-90921 Chapter 4 Printer maintenance 79
Toner catch tray and transport assembly
Thoroughly clean the toner catch tray, and clean or replace the paper transport assembly. These
assemblies are easily accessed once the fusing assembly has been removed (see “Toner catch tray
and paper transport assembly” on page 204).
To remove the toner catch tray, pull downward on the tab and slide the tray out of the rear of the
printer. To remove the transport assembly, remove the one screw (shown in Figure 6-69 on page
204) and then slide the assembly to the left. Once the assembly is free of the spline gear drive, you
can easily maneuver the assembly out of the rear of the printer. Thoroughly vacuum the assembly
and the cavity where the transport assembly rests.
When re-installing the transport assembly, there are two tabs on the right side of the assembly that
must be aligned to the printer’s frame; the white drive gear splines on the assembly must be aligned
with the driving gear mechanism on the printer.
To Next Page
Loading...