ENWW 125
4 Remove the new print cartridge
from the bag. Place the used print
cartridge in the bag for recycling.
5 Grasp both sides of the cartridge
and distribute the toner by gently
rocking the cartridge from side to
side.
6 Remove the orange shipping lock
from the new print cartridge.
Discard the lock.
7 Remove the inside sealing tape by
breaking the orange tab on the end
of the new print cartridge and
pulling the tape completely out.
Discard the tape.
8 Align the print cartridge with the
tracks inside the printer and insert
the cartridge until it is completely
seated.
Note If a cartridge is in the wrong slot,
the control panel will display the
message INCORRECT COLOR.
9 Close the front cover and then close
the top cover. After a short while,
the control panel should display
READY.
10 Installation is complete. Place the
used print cartridge in the box in
which the new cartridge arrived.
See the enclosed recycling guide
for recycling instructions.
11 If you are using a non-HP print
cartridge, check the control panel
for further instructions.
For additional help, go to
http://www.hp.com/support/lj4600
.
1
4
1
5
1
6
1
7
1
8
To Next Page
Loading...
