Control panel settings for automatic two-sided printing
Many software applications allow you to change two-sided print settings. If your software application
or printer driver does not allow you to adjust two-sided printing settings, you can adjust these settings
through the control panel. The factory default setting is OFF.
CAUTION Do not use two-sided printing when printing on labels. Serious damage could
result.
To enable or disable two-sided printing from the printer control panel
NOTE Changing settings for two-sided printing through the printer control panel affects all
print jobs. Whenever possible, change settings for two-sided printing through your software
application or printer driver.
NOTE Any changes made in the printer driver will override settings made using the printer
control panel.
1 Press M
ENU
to enter the MENUS.
2 Press
to highlight CONFIGURE DEVICE.
3 Press
to select CONFIGURE DEVICE.
4 Press
to select PRINTING.
5 Press
to highlight DUPLEX.
6 Press
to select DUPLEX.
7 Press
or to select ON to enable two-sided printing or OFF to disable automatic two-sided
printing.
8 Press
to set the value.
9 Press M
ENU
.
10 Select two-sided printing from your software application or printer driver, if possible.
126 Chapter 4 Printing tasks ENWW
To Next Page
Loading...