Replacing supplies
When you use genuine HP supplies, the printer automatically notifies you when supplies are nearly
depleted. The notification to order supplies allows ample time to order new supplies before they need
to be replaced.
Locating supplies
Supplies are identified by their labeling and their blue plastic handles.
The following figure illustrates the location of each supply item.
Figure 7-1 Supply item locations
1 Fuser
2 Print cartridges
3 Transfer unit
Supply replacement guidelines
To facilitate the replacement of supplies, keep the following guidelines in mind when setting up the
printer.
■ Allow sufficient space above and in the front of the printer for removing supplies.
■ The printer should be located on a flat, sturdy surface.
For instructions on installing supplies, see the installation guides provided with each supply item or
see more information at
http://www.hp.com/support/clj4700. When you connect, select Solve a
Problem.
CAUTION Hewlett-Packard recommends the use of genuine HP products in this printer. Use
of non-HP products may cause problems requiring service that is not covered by the Hewlett-
Packard extended warranty or service agreements.
ENWW Replacing supplies 167
To Next Page
Loading...