does not have any
wrinkles or dents from
handling, and that the
media is not
contaminated with
visible fingerprints or
other foreign substances.
■ Make sure that the
following supplies are
seated correctly:
■ fuser
■ transfer belt
■ Inspect the jam areas
and remove any
undetected jammed or
torn media.
follow the diagnostic
procedure listed on the
first page to help isolate
the defect to a particular
component.
Skewed, stretched, or off-
center page
■ Make sure that the
operation and location
requirements of the
printer are met.
■ Make sure to use
supported media.
■ Make sure that the
media is loaded correctly.
■ For problems with page
skew, turn over the
stack of media and
rotate the stack 180
degrees.
■ Make sure that the
following supplies are
seated correctly:
■ fuser
■ transfer belt
■ Inspect the jam areas
and remove any
undetected jammed or
torn media.
ENWW Print quality troubleshooting 261
To Next Page
Loading...