Power supply (high-voltage)
CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do
not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their
connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA.
1. Remove the following components:
●
Right cover. See
Right cover on page 103.
●
Left cover. See
Left cover on page 105.
●
Control-panel module and memory-card reader. See
Control-panel module and photo-card
reader PCA on page 111.
NOTE: The HP Color LaserJet CP1210 Series Printer does not have a memory-card reader.
●
Rear-side cover. See
Rear-side cover on page 115.
●
Rear-upper cover. See
Rear-upper cover on page 116.
●
Top cover. See
Top cover on page 119.
2. Disconnect one FFC (callout 1; J107).
Figure 6-64 Remove the power supply (high-voltage; 1 of 6)
1
136 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...