Power supply (fuser)
1. Remove the following components:
●
Right cover. See
Right cover on page 103.
●
Left cover. See
Left cover on page 105.
●
Rear-side cover. See
Rear-side cover on page 115.
●
Rear door and rear-lower cover. See
Rear door and rear-lower cover on page 117.
2. Remove two screws (callout 1) and the power-supply cover (callout 2).
Figure 6-80 Remove the power supply (fuser; 1 of 5)
1
2
3. Disconnect three wire-harness connectors (callout 3).
Figure 6-81 Remove the power supply (fuser; 2 of 5)
3
146 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...