11. Rotate the end of the power supply near the control-panel module out and away from the product
until it clears the chassis, and then slide the power supply toward the control-panel module to
remove it.
NOTE: As you remove the power supply, feed the wire harness at the rear of the product through
the opening in the chassis.
TIP: Make sure that the tab on the right end of the power-supply chassis fits into the slot on the
product chassis when the power supply is reinstalled.
Figure 6-79 Remove the power supply (low-voltage; 10 of 10)
2
1
ENWW Internal assemblies 145
To Next Page
Loading...