Solve connectivity problems
Solve direct-connection problems
If the product is experiencing connection issues while directly connected to a computer, complete the
following steps:
1. Make sure that USB cable is no longer than 2 meters (6 feet).
2. Make sure that both ends of the USB cable are connected.
3. Make sure that the cable is a USB 2.0 Hi-Speed-certified cable.
4. If the error persists, use a different USB cable.
Solve network problems (HP Color LaserJet CP1510 Series Printer only)
Check the following items to verify that the product is communicating with the network. Before you begin
this troubleshooting procedure, print a configuration page. See
Print information pages on page 36.
1. Are any physical connection problems evident between the workstation or file server and the
product?
Verify that the network cabling, connections, and router configurations are correct. Verify that the
network cable lengths meet network specifications.
2. Are the network cables connected correctly?
Make sure that the product is attached to the network through the appropriate port and cable. Check
each cable connection to make sure that it is secure and in the right place. If the problem continues,
try a different cable or connect to different ports on the hub or transceiver. The amber activity light
and the green link status light next to the port connection on the back of the product should be lit.
3. Can you "ping" the product? (Windows)
a. Click Start, click Run, type cmd, and click OK to open an MS-DOS command prompt.
b. Type ping followed by the product IP address. For example, type: ping 192.168.45.39
If the ping command is successful, a list of replies from the product appears in the window.
c. If you can ping the product, verify that the IP address configuration for the product is correct
on the computer. If it is correct, delete the product, and then add it again.
-or-
If the ping command failed, verify that the network hubs are on, and then verify that the network
settings, the product, and the computer are all configured for the same network.
4. Have any software programs been added to the network?
Make sure new programs are compatible and that they are installed correctly and use the correct
printer drivers.
5. Can other users print?
The problem might be workstation-specific. Check the workstation network drivers, printer drivers,
and redirection (capture in Novell NetWare).
200 Chapter 7 Problem solve ENWW
To Next Page
Loading...