6. Find the IP address on the Embedded Jetdirect page.
HP Color LaserJet CP4525 Printers
Embedded Jetdirect Page
7. IPv4: If the IP address is 0.0.0.0, or 192.0.0.192, or 169.254.x.x, you must manually configure
the IP address. See the instructions that follow. Otherwise, the network configuration was
successful.
IPv6: If the IP address begins with "fe80:", the product should be able to print. If not, you must
manually configure the IP address. See the instuctions that follow.
Manual IP address configuration
If your network supports it, use Internet Protocol version 6 (IPv6) for the most secure network printing.
For networks that do not support IPv6, use IPv4. Ask your network administrator for the IP address
that you should use.
NOTE: In general, use IPv6 for Windows Vista, Macintosh, Unix, and Linux operating systems.
Use IPv4 for other Windows operating systems and for home networks.
Manually configure IPv6 TCP/IP parameters from the control panel
1. Press the Home button
.
2. Open each of the following menus. Press the down arrow
to highlight it and then press the
OK button to select it.
a. CONFIGURE DEVICE
b. I/O
c. EMBEDDED JETDIRECT MENU
d. TCP/IP
e. IPV6 SETTINGS
f. ADDRESS
g. MANUAL SETTINGS
h. ENABLE
2 Software installation ENWW
4
To Next Page
Loading...
