Table 2-4 Pre-boot menu options (4 of 7)
Menu option First level Second level Third level Description
Administrator
(continued)
Configure LAN The network can be configured to obtain the network settings
from a DHCP server or as static.
IP Mode [DHCP] Use this item for automatic IP address acquisition from the DHCP
server.
IP Mode
[STATIC]
Use this item to manually assign the network addresses.
IP Address Use this item to manually enter the IP addresses.
Subnet Mask Use this item to manually enter the subnet mask.
Default
Gateway
Use this item to manually enter the default gateway.
Save Select the Save item to save the manual settings.
Table 2-5 Pre-boot menu options (5 of 7)
Menu option First level Second level Third level Description
Administrator
(continued)
Startup Options Select the Startup Options item to specify options that can be set
for the next time the product is turned on and initializes to the
Ready state.
Show Revision Not currently functional: Select the Show Revision item to allow
the product to initialize and show the firmware version when the
product reaches the Ready state.
Once the product power is turned on the next time, the Show
Revision item is unchecked so that the firmware revision is not
shown.
Cold Reset Select the Cold Reset item to clear the IP address and all customer
settings. (This item also returns all settings to factory defaults.)
NOTE: Items in the Service menu are not reset.
Skip Disk Load Select the Skip Disk Load item to disable installed third-party
applications.
Skip Cal Select the Skip Cal item to initialize the product the next time the
power is turned on without calibrating.
Lock Service
CAUTION: Select the Lock Service item to lock the Service menu
access (both in the Pre-boot menu and the Device Maintenance
menu).
Service personnel must have the administrator remove the Lock
Service setting before they can open the Service menu.
Skip FSCK Select the Skip FSCK item to disable Chkdisk/ScanVolume during
startup.
ENWW Pre-boot menu options 111
To Next Page
Loading...