Table 2-14 Tray/bin manual sensors (continued)
Sensor or switch name Replacement part number Descriptions
SW3 Tray 4 paper size 1
SW3 Tray 4 paper size 2
SW3 Tray 4 paper size 3
NOTE: 2x500-sheet feeder, and 2,500-
sheet HCI.
RM1-5913-000CN Lifter base assembly
SW4 Tray 5 paper size 1
SW4 Tray 5 paper size 2
SW4 Tray 5 paper size 3
NOTE: 2x500-sheet feeder, and 2,500-
sheet HCI.
RM2-0350-000CN Tray size sensor assembly
SW4 Tray 2 paper size 1
SW4 Tray 2 paper size 2
SW4 Tray 2 paper size 3
NOTE: M651 and M680.
RM1-5913-000CN Lifter base assembly
Print/stop test
Use this diagnostic test to isolate the cause of problems such as image-formation defects and jams within
the engine. During this test, stop the paper anywhere along the product paper path. The test can be
programmed to stop printing internal pages or an external print job when the paper reaches a certain
position. The test can also be programmed to stop from 0 to 60,000 ms. If the timer is set to a value that is
greater than the job-print time, the product can recover in one of two ways.
1. From the Home screen on the product control panel, scroll to and touch the Administration button.
2. Open the following menus:
●
Troubleshooting
●
Diagnostic Tests
●
Print/Stop Test
3. Enter a range, and then touch the OK button.
●
After the print job is completed press OK button to return to the Troubleshooting menu before the timer
times out.
●
After the timer times out, touch the Stop button. Activate the door switch to restart the engine and
return it to a normal state.
NOTE: Do not try to perform a print/stop test while the product is calibrating, because restarting the
product might be necessary If a jam message displays on the control panel during testing, activate the door
switch.
154 Chapter 2 Solve problems ENWW
To Next Page
Loading...