Recommended action
Touch the OK button to clear this error.
USB storage file operation failed To clear touch “OK”
Description
A PJL file system command was received that attempted to perform an invalid operation, such as
downloading a file to a nonexistent directory.
Recommended action
Touch the OK button to clear this error.
USB storage file system is full To clear touch “OK”
Description
The file system on the installed USB device is full.
Recommended action
Touch the OK button to clear this error.
Used supply installed To continue, touch “OK” OR Used supply in use Description
Description
One of the toner cartridges or supplies has been previously used.
Recommended action
If you believe you purchased a genuine HP supply, go to
www.hp.com/go/anticounterfeit.
Verifying, Please Wait
Description
This message displays when the product is retrieving a print job from device memory, but can cause the
product control panel to lock up.
The user enter the Retrieve from Device Memory menu to print a job. After selecting the desired print jobs,
Verifying, Please Wait displays on the control panel. The status bar will move for a moment, and then lock
up. Typically, if the user waits a few minutes, the error will clear and the job will print.
In rare cases, the message will lock up permanently and force the user to power cycle the product.
The event log might show the following errors as a result of power cycling the product during lockup:
●
48.05.05
●
98.03.11
Recommended action
Turn the product off and then on again.
Make sure the firmware is the latest revision.
428 Chapter 2 Solve problems ENWW
To Next Page
Loading...