3. Wait for 30 seconds to make sure the data has been written to NVRAM and all changes have
occurred.
4. Turn the product off and then on. The product ID will change to the base model.
Reset the serial number of the formatter
1. Make sure the product is in the Ready state.
2. Update the file setSerialNumber.pjl file to set the correct serial number on the formatter.
For example: @PJL DEFAULT SERIALNUMBER=ABC123
3. Use hpnpf or hexprint.exe to send the setSerialNumber.pjl file to the product.
4. Print a configuration page to verify the change.
Reset the page counts on the formatter
1. Make sure the product is in the Ready state.
2. Update the file pml_pagecount.pjl file to set the correct mono and color page counts on the
formatter.
NOTE: These values are hexadecimal. The following examples show setting the mono page
count to 15 and the color page count to 10.
@PJL COMMENT Mono Page Count
@PJL DMINFO ASCIIHEX = “04000501040102060802000F”
@PJL COMMENT Color Page Count
@PJL DMINFO ASCIIHEX = “04000501040102060802000A”
3. Use hpnpf or hexprint.exe to send the pml_pagecount.pjl file to the product.
4. Print a configuration page to verify the change.
ENWW Removal and replacement procedures 145
To Next Page
Loading...