2. Disconnect one connector (callout 1), disconnect seven connectors (callout 2), and then remove
three screws (callout 3) that have a triangular icon next to them.
Figure 2-92 Remove the low-voltage power supply (1 of 3)
2
3
1
WARNING! When disassembling the low-voltage power supply unit (callout 1), do not touch the
electric element (callout 2) as shown. Be sure to hold the bottom side of the low-voltage power
supply unit.
1
2
ENWW Removal and replacement procedures 149
To Next Page
Loading...