Imaging (developing) high-voltage power supply
Before proceeding, remove the following components:
●
Rear cover. See
Rear cover on page 93.
●
Right-rear cover. See
Right-rear cover on page 95.
●
Formatter case. See
Formatter case on page 123.
Remove the imaging (developing) high-voltage power supply
CAUTION: ESD-sensitive part.
Remove one screw (callout 1), release four tabs (callout 2), remove the cable routing plate (callout
3), and then remove the imaging (developing) high-voltage power supply PCA.
Figure 2-95 Remove the imaging (developing) high-voltage power supply
1
2
3
4
Reinstallation tip Reinsert the power supply by angling the smaller left end behind the DC
controller and driver PCA. Ensure that the power supply sits behind the black tab (callout 4).
Carefully press the power supply to engage all four tabs.
152 Chapter 2 Removal and replacement ENWW
To Next Page
Loading...